Control Valve Repair in Yellow Pine, ID

Control Valve Repair in Yellow Pine, ID

Control valve repair in Yellow Pine, ID covers the head on top of your softener, the part that runs every cycle. Yellow Pine, ID Water Softener Installation works on the common valve families found in homes, including Fleck 5600 and 7000 series and Clack WS1 units, along with many brand-name dealer valves.

When the valve fails, the symptoms are usually clear:

• Water running to the drain long after regeneration should have ended
• A grinding or clicking motor that never finishes a cycle
• The display losing its time or showing an error code
• Low water pressure through the softener
• Hard water even though the salt level is dropping

Most of these come down to worn piston seals and spacers, a cracked drive gear, a failed motor, or a bad circuit board. We remove the valve head, inspect the piston assembly, and replace the seal and spacer stack with a matching kit. If the motor or board is gone, we swap it. Then we reprogram hardness, time and salt dose and run a full regeneration while we watch each cycle step.

If parts for your valve aren't made anymore, we'll tell you and quote a replacement head that fits your existing tank.

For control valve repair in Yellow Pine, ID, call Yellow Pine, ID Water Softener Installation at (833) 995-0133.